Skip to content

Heat Pump Hot Water Redhead

Heat pump hot water in Redhead uses a compressor to pump warmth out of the yard air into the cylinder, and that cuts the power it needs to heat water. Your plumber in Redhead sizes the unit, gives a fixed quote and installs it, removing the old tank on the same job. Ring to book a measure-up.

Licensed plumbers and gas fitters · NSW Lic. 359278C

Last updated September 2026

Storage hot water unit fitted against a house wall

Why Switch to a Heat Pump Here?

Three reasons make the case:

Running cost

A compressor shifting heat draws a small share of the power a plain resistance element needs.

The climate suits it

Redhead records no frost days on average, and mild air is where a heat pump does its best work.

Replacement timing

Outdoor tanks near the beach can rust out early, and that is a natural moment to compare a heat pump with a like-for-like tank.

For the fix-or-swap question, and heat pumps weighed against gas and solar, see hot water systems.

Newly installed storage hot water unit

How a Heat Pump Install Goes

Here is the order of work:

  1. 1

    Measure-up

    We ask how much hot water the house uses, find a spot for the unit and check the pipe and power supply, then recommend a size.

  2. 2

    Fixed quote

    We provide up-front, honest quotes that will always match the final price, should you decide to go ahead. Nothing is ordered until you approve the figure.

  3. 3

    The install

    We drain and remove the old cylinder, set the heat pump on a slab or bracket, connect the pipework and commission it with a timer that suits your day.

  4. 4

    Warranty and handover

    We show you the settings and basic upkeep, and every install carries our 365-day warranty on all work.

What Shapes a Heat Pump Price?

Capacity comes first:

Tank capacity

A couple needs a smaller unit than a family in a four-bedroom house.

Pipe changes

Moving the unit to a new spot or replacing old galvanised supply adds parts and hours.

Power supply

A suitable circuit already in place is simple. A switchboard that needs an electrician first adds a separate cost.

Taking the old unit away

Including disposal.

A tank that is weeping rather than dead gets traced by the water leak detection team first, so the right problem gets fixed.

Electric storage hot water unit after installation

Where the Unit Sits Matters on This Coast

Salt spray decides the mounting spot

Redhead's constant salt-laden onshore wind makes saltwater corrosion the main threat to any outdoor unit, more so on houses closest to Redhead Beach.

A heat pump spends its whole life outdoors

Its fan, coil and casing take that wind every day, so our first choice is a sheltered wall or the side of the house away from the wind, before settling on a sea-facing spot.

Mild winters help

With no frost, the coil does not ice up, and a heat pump keeps its efficiency through the cooler months.

"[The plumber] & his young helper were courteous, well mannered & competent when replacing the solar hot water station pump at my property" Jennifer

When We're Not the Right Call

A heat pump that needs its own circuit, or a fuse board that has to be replaced first, is a job for an electrician, and we flag it when we quote. Moving the unit onto a new slab or wall bracket is ours, but building work around it is a builder's.

Heat Pump Questions Answered

Does the salt air here shorten a heat pump's life?

It can. The fan, coil and casing live outdoors, and saltwater corrosion here is among the worst in the council area. We pick a spot out of the direct spray where the yard allows, and each service includes a look at the casing.

Is a heat pump a sensible fit for an older cottage?

It can be, depending on the house. Some cottages still run old galvanised water pipe, and an old fuse board may need an electrician first. At the measure-up we check pressure, pipe condition and the power supply before recommending anything.

Can you service the heat pump unit I already have?

Yes. We service and repair existing heat pumps as well as installing new ones. If yours has gone cold, started rattling or is showing a fault code, the fault gets diagnosed and priced before any part is changed.

What happens to hot water while a heat pump is on order?

While you wait on stock, we can connect a temporary tank so nobody is stuck with cold showers. Ask about it when we quote, and it comes out once the heat pump is running.

Need a plumber? Call or send the form

Call (02) 4093 0558 or send the form below. Available 24/7, you see a fixed figure ahead of any work, and every job carries our 365-day warranty on all work.

Call (02) 4093 0558

Request a callback

Leave a name and number and a plumber will ring you back.

We use your details only to call you back about this job. See our privacy policy.

Call (02) 4093 0558 Get a quote